New Electric Agitator Digital Display Lab Overhead Stirrer Mixer Variable Speed

Description

Overhead electric agitator, DC permanent magnet motor, low noise, maintenance-free. Stable start, overload protection, loop protection, adjustable speed, precise and controllable.
feature:
1. Competent for high load
Can work continuously for a long time and perform well.
2. Condensation tongs are wrapped in rubber
The condensation tongs are wrapped in rubber, which increases friction and effectively clamps the container. The torque can be adjusted automatically according to the change of sample viscosity.
3. High and low speed, accurate and controllable
CD shows the set value and actual value of speed, and can monitor the speed and time in real time. The speed range is wide 200-3000rpm, constant speed, high and low speed can be accurately controlled.
Range of use:
It is a good tool for petroleum, chemical, metallurgy, textile, food, medicine and sanitation, environmental protection, biochemical laboratory, analysis room, education and research.
parameter:
Large mixing amount (H, O): 20L
Motor input power: 72W
Motor output power: 60W
Mixer power: 80W
Voltage: 100-240V
Speed: 200-3000rpm
Speed ​​display: LCD
Variable speed: 20rpm
Torque: 40 (N/CM)
Overload protection: automatic shutdown
Maximum viscosity [MPAS]: 10000
Drilling chuck clamping diameter range [VAC]: 0.5-10
DIN EN60589 protection method: IP42
Allowable ambient temperature [°C]: 5-40
Allowable ambient humidity [%]: 80
Steps:
Press and hold the right button to start, press the setting button to select the setting
① Press the setting button once, the mode flashes, press the upper and lower two buttons in the middle to select the mode, there are three modes corresponding to different speed and time respectively.
② Select the mode, press the setting button again, the RPM flashes, and use the up and down keys to set the desired speed per minute.
③ After setting the speed, press the setting key, Min flashes, use the up and down keys to set the required timing time, the speed reaches the set speed after starting, and the timing starts.
④ Set the above parameters in a specific mode, long press the set button, the screen flashes, indicating that the parameter has been saved in this mode, next time only need to select the mode corresponding to the set speed and time, press the right button to start and pause, long The key is turned off.
The package includes:
1 *Host
1 *Stirring rod
1 * Pillar
1 * thick bottom
On Jun-15-21 at 08:38:08 PDT, seller added the following information: